Models:

Without Basin (PMM)
With or Without Lower Frame

• Motor-fan (axial) group with gearbox reducer, low
  installed power, possibility of low noise levels, IP 56
  Siemens motors
• Casing made of FRP sandwich panels, thickness 22
  mm
• Metal frame in hot dip galvanized steel after
  fabrication (galvanization process in accordance
  with UNI EN ISO 1461-99 regulation, thickness not
  inferior to 80 micron)
• Water distribution system in PVC, PP or PE
  equipped with non-clogging PP spray nozzles
• Fill pack with different kinds of air

• 19 mm (PVC or PP*) fill material for industrially
  clean water, with maximum temperatures of +55
  °C (PVC) and peaks up to +80 °C (PP)
• GS-L (PVC also available for high temperatures)
  panels for dirty water, developed by MITA to
  provide maximum heat transfer by combining an
  effective splash effect to a film component
• GS (PP) grids for very dirty water (suspended solids
  and colloids witha diameter <200/300 microns,
  concentration <1000 mg / l) and with a maximum
  peak temperature of +80 °C.